How To Refinish Dining Room Table

Refinish dining room table – It repainting your old dining room table will, worn tables below with a new life and a pleasing appearance. Scratches, dents and fading occur around the dining tables. If the damage is the sun or years of wear and tear, refinishing your round dining table can be an effective way to give your room a new look without breaking the bank. c

Stylish Refinish Dining Room Table

To refinish dining room table are Apply a thick layer of paste finish remover to the table, using a natural bristle brush. Allow the finish remover sit for a few minutes until bubbly and raises the surface finish. Scrape off the old finish, using a wide spatula. Scrape with the grain of the wood to avoid scratching the table. Apply liquid separator to the surface of the table using a natural bristle brush. Allow the liquid remover sit for a few minutes.

Related Posts:

Remove the separator residue dipping a steel wool pad medium well in lacquer thinner. Gently wash away the residue of the surface, working with the grain of the wood. Of sand the surface with a finishing sander and sandpaper 220 grit to smooth imperfections. Apply a blur of wood with a natural bristle brush. Apply three layers of transparent polyurethane layer to the surface of the refinish dining room table using a natural bristle brush. Apply a wax finish to the surface, using a steel wool pad super good.

Tips To Refinish Dining Room Table

Wood is unlike all other woods. Although it is considered a hardwood, it has an unusual curly grain pattern that creates many problems for the wood finisher during dyeing and finishing. First, remove any finish that is left on the table. Although you should never sand bare wood with a coarse sandpaper (60 or 80 grit) -usually, the darker finish, the rougher the paper you use you have to do it here to remove the old finish. Once the finish has been removed, smooth bare wood with 120, 220 and 320 grit sandpaper. Always sand with the grain pattern if possible. Pay attention to small cracks and carving. Use a dental pick to get into hard to reach

Wood darkens over time without any stains. But if you want the dark color immediately, stains on the table with a stain. First, the state of the wood with an oil-based wood conditioner; oil-based products dry faster than water-based. Be sure to get conditioner in the end grain of the wood, too. Missing condition the wood will result in stains in France pattern of wood grain and darker end grain. Leave conditioner dry per instructions on the can, and then use an oil-based gel stain. The gel stain will also help prevent stains. Apply stain more than once if you want a darker color. When the piece is completely dry, apply the finish.

Apply one coat thinned polyurethane finish (1 part thinner to 4 parts polyurethane) with a rag. Once this coat has dried, wipe the table with 3/0 steel wool. The wool will smooth out any unevenness areas of glaze coat and knock down some rough grooves or bubbles. Apply another two or three layers of polyurethane untinned, with a fine brush or by wiping it on. Select satin, semi-gloss or gloss for the finish.

6 How To Refinish Dining Room Table Photos

Comments are closed.